I did the same test of "conventional" vs "climb", but with bigger tags. These were programmed as "tag width" = 10mm, so the tags should have been 5mm deep. I measure one, it was 4.97mm deep.The following measured at about 5mm below the top:
CV
x width = 19.82mm
y width = 19.83mm
CB
x width = 20.09mm
y width = 19.97mm
2 comments:
CV vs CB has many factors. One large factor is machine stability.
On a home-built machine that uses an ACME thread with backlash it is better to conventional mill. One that uses ballscrews could get away with climb milling.
what was your setup?
I have ballscrews. This is my machine:
http://www.arceurotrade.co.uk/Additional-Departments/Special-Offers/Sieg-KX1-Hobby-CNC-Mill
Post a Comment